The machine operated edition of 2383HT01: 

tool                   swaging adaptor  swaging angle     for grommet

2383PT01-1AY  2383MP01-1AY    30°                    GF14

2383PT01-2AY  2383MP01-2AY    45°                    GF14

2383PT02-1AY  2383M902-1AY    90°                    GF15

Step1:

-Insert stud nut with grommet into properly prepared hole of the panel.
-Engage the threaded rod of the HS-screw to the stud nut and screw it in ,until it stops.

Step2:

-Preload the Camloc Hand Tool 2383HT01 by screwing the nut hand tight along the MS-screw ( see drawing )in order to fix all components in the correct position for flaring.

For proper alignment preferably clamp the panel with the 140° countersunk surface to a plain surface ,so that the nut and the grommet are pushed into the hole.

 Step 3:

Hold the HS-screw firmly by HS-driver, if necessary pulling the grommet into the hole,and turn nut with a torque limiting wrench for approximately one half rotation until you feel or hear that the torque limiter has reached its pre-set torque.

An adjustable torque limiting wrench must be set to 3,7 to 4,5Nm to apply the correct flaring force of 3000N
These values are valid for all stud diameters and for all flaring angles .

Step 4:

Finally unscrew stud nut from the of Camloc Hand Tool 2383HT01 tool and bring tool back into starting position